shear pin on rear jacks??

[Jimalberta]

Hi ...I was raising my jacks and went a little too far and broke the pin that connects the motor to the worm gear. Has anyone replaced it before? I need to know if this is a specifically designed shear pin or just a standard pin. For temporary I am using a nail but need a more permanent fix.

Thanks
Jim

 

[JohnDar]

You could try Lippert for a replacement. You'll want something with the same shear properties, should it happen again.
(866) 524-7821

 

[wdk450]

Here is a manual for the rear stabilizer: http://manuals.heartlandowners.org/...ing/Lippert/Electric_Rear_Stabilizer_Jack.pdf

The lowest part containing the pin is the "motor drive coupler" item 8 on page 9.

This is on the "Tools" tab on any forum page; "Manuals" , "Exterior", "Stabs n Levelling", "Lippert".

You still need to call Lippert, now you know what to ask for/refer to.