BruteForce
Well-known member
**I couldn't find an area to post this in, so I'm sure if one exists, a moderator will move as appropriate**
Today, while installing scissor lift legs in the rear of my rig (the OEM units were garbage and kept binding, so I removed the electric unit), I noticed that the plastic coated cardboard covering the under-belly was coming loose mainly along the middle; it was bowing quite a bit in the center and there was water accumulating. It would seem that the center "screws" or whatever they are/were had come undone and the entire mid-section was hanging low.
How to fix?
I'm thinking about cutting about 6x pieces of sheet metal (maybe 2" wide), drilling holes in the frame rails and using those to hold up the under-belly sheet.
Any ideas/fixes appreciated.
Today, while installing scissor lift legs in the rear of my rig (the OEM units were garbage and kept binding, so I removed the electric unit), I noticed that the plastic coated cardboard covering the under-belly was coming loose mainly along the middle; it was bowing quite a bit in the center and there was water accumulating. It would seem that the center "screws" or whatever they are/were had come undone and the entire mid-section was hanging low.
How to fix?
I'm thinking about cutting about 6x pieces of sheet metal (maybe 2" wide), drilling holes in the frame rails and using those to hold up the under-belly sheet.
Any ideas/fixes appreciated.