Found out I didn't hit anything. The RV is wired wrong. Will make 2 hour trip to dealer when time permits. Anyone else run into issues with cable/satellite/antenna wiring? Cable was actually wired as satellite, antenna would not send signal to main tv, storage compartment had no signal except satellite, garage is ok.
I'm not making any excuse for why your system is not working - but I can give some general insight and guidance.
For what it's worth - the wiring in the RV, be it for antenna, cable or satellite is all the same wiring. What makes a jack a Satellite jack versus a Cable jack is only a function of what signal is sent down the wire to the jack.
Generally, the satellite cabling goes from the roof to the UDC. Then from the UDC to the livingroom and bedroom. Generally, the Cable input in the UDC goes directly to the Antenna wallplate that has the amplifier switch on it. Generally, the Antenna output goes directly to the Antenna wallplate that has the amplifier switch on it. From that Antenna Wallplate, an output is distributed to various Antenna/Cable jacks in the RV. In some cases, there may be a splitter in that distribution. And this is fine for antenna/cable signals.
I used the word "generally" a lot above. This is because I am not familiar with how Razor is wired for entertainment. I am drawing on how I have generally come to know our RVs being wired.
If you have an interest and skills to tackle the job, through the use of a toner/tracer (
$19 delivered at Amazon.com), you could tone out the lines to determine their routing, then swap whatever needs to be.
If I had to guess, I'd say behind the UDC, on the back side of the Cable and Satellite wallplates, the wires got swapped. Something to consider versus a 2 hour each way trip to the dealer plus down-time.
Jim
View attachment 7069