Project LM 365
- Thread starter Jesstruckn/Jesstalkn
- Start date
-
- Tags
- locks
Jesstruckn/Jesstalkn
Well-known member
It also helps with level up.
That is a understatement !!!! Level-up is incredible for doing this type of work. It's like having a shop lift where ever you go.
Bones
Well-known member
Your really hauling on your Rv pigtails. It makes me want to take mine apart and redo it.
Jesstruckn/Jesstalkn
Well-known member
Yes I have them pretty dialed in now. I just need that app to turn them all on at once.
Sent from my SM-N950U using Tapatalk
Sent from my SM-N950U using Tapatalk
travlingman
Well-known member
On the battery charging issue, I might have missed it if this was said, but on the 2017 and up Ford's with the truck running you have to depress the brake for the charging to work.
Jesstruckn/Jesstalkn
Well-known member
I remember something like that but couldn't remember what it was.
But that seems kinda strange but I'll try it.
I think I'm just going to run my own wire from the batteries back to the 7-way plug.
Sent from my SM-N950U using Tapatalk
Jesstruckn/Jesstalkn
Well-known member
I just went in underneath and secured the center of the rear wall with a big lag bolt through the cross member into the lower cross beam of the wall. So now next time I have the couch out I can remove that angle iron from inside as it's no longer needed.
Sent from my SM-N950U using Tapatalk
Sent from my SM-N950U using Tapatalk
Jesstruckn/Jesstalkn
Well-known member
Update on this repairOk this is where I'm at with this fix.
I have pre drilled the 1.5"×1.5" stud and screwed it in in 2 places on each side. Using the access from the taillights. It is solid as heck but my plan was to do more inside. This will be behind the couch so you'll never see it. I'm on the fence right now of whether I should do it or not.
Sent from my SM-N950U using Tapatalk
https://heartlandowners.org/showthread.php?p=587366
Sent from my SM-N950U using Tapatalk
Jesstruckn/Jesstalkn
Well-known member
As soon as I figure out how to work this forum they change it on me. I can't keep up.
Sent from my SM-N950U using Tapatalk
Sent from my SM-N950U using Tapatalk
jnbhobe
Well-known member
Wasn't the left rear where you had the brake problem make sure you don't have a frozen caliperI also did the new brake pads and repacked all of the wheel bearings. While I had the tires off replaced 1 tire and balanced all 4. Replacing that 1 tire is what started this all. That's when I found out how bad my brake pads were. All of the wheel bearings looked really good, I did have a little bit of discoloration of the grease from heat on the left rear. But not bad at all.
As you can see in the pictures I had just done my new Dexter HD shackle and equalizer kit that I won at the Jackson CA. rally last year. I think we are about ready to hit the road again.
The tire I replaced had a flat spot on it and was getting worse on every trip.
It's sure is nice to be able to work on it right on the side of my house. I even have shade.
Sent from my SM-N950U using Tapatalk
Sent from my SM-G950U using Tapatalk
travlingman
Well-known member
Depress it a few times. When I went to pick my camper up from having the dealer work on it, they had drained the batteries. Hooked up cord and couldn't get landing gear to go up. Finally remembered about the brake, had to depress a few times, take it in until you have full pedal.
I replaced mine last year after around 40K miles. Looked to have about 50% remaining.
I do use the engine brake and don't do much towing in a city.
Since the calipers have to be removed when repacking bearings a person might as well change out the pads while they are accessible.
I don't repack often.
Like anything that can wear your mileage will vary on how you use it.
Peace
Dave
5
Jesstruckn/Jesstalkn
Well-known member
FYI.
I'm making up a new batch of Docking Donuts for the Washington and Oregon rally.
I know a few of you out there have asked for these not to long ago. Please PM me again and I'll get one out to you.
Sent from my SM-N950U using Tapatalk
I'm making up a new batch of Docking Donuts for the Washington and Oregon rally.
I know a few of you out there have asked for these not to long ago. Please PM me again and I'll get one out to you.
Sent from my SM-N950U using Tapatalk
Jesstruckn/Jesstalkn
Well-known member
Greengas
Well-known member
Forgot the picture
Sent from my SM-N950U using Tapatalk
Ok. What is a docking donut
Jesstruckn/Jesstalkn
Well-known member
Jesstruckn/Jesstalkn
Well-known member
TikiDawg
Well-known member
Jerrod,
I missed out on the original batch.
Save me one please.
Thanks.
Steve
Sent from my XT1650 using Tapatalk
