Found the following recalls on RVs. Appears to be related to Winntec model 6020 two-stage propane regulator. Note the Heartland recall at the bottom below is for improperly tightened gas line not the regulator.
Jayco Inc. is recalling 87,649 2017-2018 Jayco Designer, 2017-2021 Eagle HT, Eagle...
On both the RVs I have owned the red light would only be on after the initial start up if the HW heater failed to light. The light would go out if it was successful. Also some HW heaters have the electric element switch inside the panel out side.
Stick the end of the hose through one of the vent holes. To remove the cover completely in the future you will need to remove the drain from the vent hole temporary.
The awning operates on the 12 volt DC supply. You need to verify you 12 volt system voltage. It could be low due to a bad battery or a failed 120volt AC to 12 volt DC convertor or breaker. If OK then you need to check the voltage at the awning motor while operating. A low voltage there could...
Have you tried a different regulator or no regulator? The regulator although a pressure regulator, regulates by controlling flow. If the mechanism has become clogged or damaged it maybe still regulating pressure when at a low flow rate, but cannot open enough to allow the higher flows required?
I have had that feeling before. It was caused by the brake pad de-bonding from the brake shoe. This allowed the brake pad to float around in the drum which would cause that particular brake to try to lock/brake randomly. The brakes would operate correctly otherwise. I have had this happen on...
You may want to check the tires for balance and/or for being out of round. Typically RV tires do not come balanced. If you have ever had a severely out of balance tire on your car you can imagine what maybe happening with one on the RV.
My RV had wiring from the Radio/DVD player to the TV, but it was hooked up to allow surround sound through the TV when playing a DVD. It was hooked up on the DVD player to the audio out and the TV on Audio in. Thus the TV had the DVD audio when a DVD was playing. I changed the wiring on the TV...
Check the seal on the bottom of the slide. My slide above the wheels, had a d seal but was about 1/2" from contact. I installed an additional d seal on the opposite side to make the seal complete.
I also, recently had a bar come loose on one end on my Fuel 305. I replaced the Tek screws with 1/4"-20 rivet nuts and 1/4" hex screws. i assumed a larger Tek screw would eventually fail also? By using the rivet nuts, I did not have to drop the chloroplast or get access above the crossmember...
If you have the fan in automatic it will switch between high speed and low speed depending how far above set point the temp is. When it switches the fan will shut down completely while switching. The compressor continues to run. I don't remember the time but it will shut down but it is around...
Something is not correct about your current setup. Some possibility if heating correctly, is the HW bypass in wrong position, or the check valve on the HW heater is bad.
Based on my research the best option is probably the MicroAir EasyTouch RV thermostat. I have considered upgrading to this unit but so far the original device is working.
Make sure you water heater bypass is in the correct position. There will be three valves near the HW tank or a three way valve near the tank used when winterizing the unit. If a three valve system check to insure the middle valve is closed connecting the hot water line to the cold water line...
Had the same issue. My TV and audio system had wires run from the TV to the Audion system but was set up to have the audio from the DVD go to the TV. I changed the connection on both ends by plugging the wires on the TV to audio out and the audio system to audio in. Now i can set the audio...
Since your pump runs but dies not pump is it possible that the DC voltage going to the entire system is wired backward? If the geared pump runs in the wrong direction it will not pump. Could be instead of past issues on other units with the gauge being wired backward, everything is?
Yes they can be repaired. You can buy spin welding fitting and do it your self or take it to a plastic tank manufacturer.
https://www.youtube.com/watch?v=t2Lnknw2Rmg
https://www.youtube.com/watch?v=fMdLWAYr7Ck
Not sure what the problem is but it sounds like you may have lost your 12 volt supply to the Tstats. The 12 volts it typically feed from AC unit area to the Tstat when just one unit. Not sure when you have three units. There may be a central control panel.
If only one tire temp is higher than the others and the pressure is similar, it could indicate a brake or bearing problem on that wheel. You need to compare the hub temps by feel or by using a heat gun. I had this issue and a brake shoe had come unbonded on one wheel and was dragging all the...
I certainly cannot say this is not the way yours is plumbed, but it makes no logical sense for them to pipe around the front gray tank with the shower to the rear tank. This also puts the two high use items in the same tank?? You can look under the shower and see which direction the drain goes...
Eastwood has some great rust encapsulator paints and frame paint selections.
https://www.eastwood.com/eastwood-rust-encapsulator-black-aerosol-15-ounce.html?SRCCODE=PLA00010&gclid=EAIaIQobChMIqfmzooKi6QIVmYjICh3c9ADFEAQYAiABEgJ2AvD_BwE
John,
Please reread my post. I said the kitchen feeds one 30 gal gray tank and the sink and shower in the bath feed the other 30 gal gray tank. I don't think there is an over flow connection but i am not sure, as when one shows full i usually empty it.
Thanks,
Tim
Mark,
Your Torque 285 appears to be the same as my Fuel 305. On my unit the front dump connection is for the grey tank for the bathroom sink and the shower. The rear grey connection that is Teed into the black dump connection is for the Kitchen sink. I do not remember which one is which on...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.