Search results

I would consider putting some type of long boards to somewhat bridge the 'dip"--this should also lift the rv some to clear the rear. Use something wide like a 2x10. al

I have a 2010BH that had frame flex, but nothing wrong with the kingpin---yes I did take it to IN and was treated VERY WELL---fixed me up in about a week and was on my way--no further issues. al

Thanks everyone--knew I would get great responses from this group. My pictures all came out too black to post however my tires look like several of the pictures that have been posted. Perhaps it is the turning that is causing the tires to wear on the inside and outside. I do appreciate that...

Hello, I have a BH 3670 and have GY 614's. I also have center point suspension system. I have noticed that the tires on the refer side are wearing on the outside of the tire, both front and rear tires. I tried pictures but they do not show the wear (too dark). Several have suggested it is not an...

The seals are not hard to replace as a DIY project. However if you have leaking you may want to also consider having your slides checked for proper alignment. al

I would check power coming into your switch. I think? power goes to that switch prior to going onto the heater. If it is low then go to fuse box and see if by chance you have a weak circuit breaker. You should get several other responses from others who are more knowledgeable than me!! al

Hi everyone, We have a 2010 BH that I have always waxed with a polimer about 2 times/year. However it is starting to get small blotches on the surface, like the wax is still there and not coming off. Is that some form of oxidation? and what do you recommend to fix the issue. I tried a few...

Thanks everyone. I thought the pressure was the same at 70, but will double check each tire. We are volunteering in crystal river, FL. al

Hi everyone, I have a question on my tow vehicle tire wear--I could ask dealer or alignment people but get a lot better advise here. I have a 2005 Silverado 3500. Got it aligned about 1.5 years ago at Henderson's in grants Pass (who I would recommend), but am now in FL and do not have confidence...

We have been traveling for 8 years and never had any extra tie downs--however I have thought about it, but never been an issue al

Thanks everyone----this is by far the best place for information and ideas---yes, it was the board---I did get it replaced and all is fine now--learned a few things for future--appreciate all your help currently volunteering at Crystal River National wildlife al

we are full timers and declare Fl as resident---Our mail service is located in FL and use that as an address. They are America Home Base--located in Pensacola. al

Hello, we have a BH 3670---2010---this morning I moved the thermostat up and got nothing from the furnace. I checked wires in the thermostat, putting one on ground and the other going to each colored wire and have voltage to each. The fan will not come on. I checked the fuses and all seem to be...

you have some great advice, I'll add one more thing to check that caused a neighbors to not work. The rain sensor was dirty ( I guess the same as having water on it?)--cleaned it up and all was fine. al

We have a 2010 BH 3670 and the Fontana outside shower is leaking at the faucet. I have completed some trouble shooting and found that the faucet is not completely closing. I have it completely apart and wondering where to get an "o' ring, small spring, and a rubber nipple that fits over the...

Hi everyone, We have a 2010 HL Bighorn. The "plastic" drain tube for the refer has become brittle and kinda falling apart. I checked with a few local RV dealers and they did not have the part, but suggested using vinyl tubing? Since we are currently in a remote location cannot get to a larger...

thanks everyone---I feel considerably better now knowing that perhaps I did have some correct information. I now also know the process to help these new shoes conform to the drums. I did get the complete backing plates when they were replaced. Thanks again--really appreciate the quick response al

Hi everyone, I need some help. Currently in AZ and was time to get wheel bearing repacked. Trailer Sales was recommended so made an appointment. Here is what happened---one of my seals was blown out so grease into the brake on the rear--so in additional to the bearings they replaced both rear...

thanks--so if I pull down on the knob and turn it I should be able to open manually?? I tried this but wow, it feels like something is going to break? al

Not sure if you want to stay in the gulf area. It may be a little chilly(not cold) and there will be less people. If so try Pensacola RV park---the owners are on site all the time and you will not find a nicer couple to help you with anything. al currently in AZ

hello, We have a fantastic fan in Kitchen (2010 BH--3670) and at first it was not opening properly. A friend suggested to clean the thermostat, did that and then it was working fine, however now the lid will not open at all--the turning mechanism will start to turn but with the lid not opening...

Not sure how far North you want to go, but volunteered at the Apostle Island National Lakeshore last summer, north of Bayfield. If you have time, it is quite a place and has a small town run campground right on the lake. al

Volunteered here a few years ago--if you have time go to Shark Valley al

Not sure how many batteries you have, if only one then you should?? be ok for one night, two (when it is cold) would be stretching it. If you have two batteries and they are in good shape you should?? be able to go three nights. al

JohnD, When you were at Camping world, did you happen to find a door handle with an off set in the back? I had looked here outside of Phoenix with no luck, they were all flat on the back. thanks al

Woops---just checked Lippert web and then called--they said theirs were flat on the back and that will not fit properly---I may?? end up either slicing into the back of a new one or grinding off the lip on the door---would appreciate any other suggestions. al

Thanks will give Lippert a call

Hi everyone, we have a 2010 HL 3670 Bighorn and need a new screen door handle--thinking no big deal, go buy one--I did, however when I did remove the old one I found out it is not flat on the back but has an off-set to fit in a groove in the door. I cannot find one in any rv store with the off...

I had a similar issue--mine was coming in from the vertical seam where the cab hits the side---I also had some coming in from the horizontal seam at the bottom of the cap---used a water hose to find them and recaulkd and did not have an issue. al currently in AZ

Had the same issue and did have to cut the "ears" off the one I bought--no big deal---it did solve the problem al currently in AZ

Congratulations---you will enjoy it. There are a lot of knowledgeable people on this forum who can solve about anything---also look forward to your input as you move forward. al currently in AZ

Re: ATF: Bighorn - waste valves You have probably already did this for regular maintenance, but if by chance you did not. Each valve has a small "piston type" right near the valve (you need to drop the belly to see it). I usually put a few drops of silicone on this when I'm under there. al...

Hello everyone, This is a new one for me. We have a 2010 Bighorn, 3670. We have been parked for a month or so. The inside skin of the exterior door is cracking. It started on both sides of the window and ran horizontal to the edge of the door. Now, we have noticed another crack starting about...

We spray our with spray cooking oil about once every two weeks or so. You may also have a weak return spring, not too bad to replace. al

hello everyone, I need some advice. I have a Watts 263 regulator that again allows pressure to go up---this is the second one of these I have had, the first did the same. I have rebuild both of them several times and still have pressure slipping by. I have contacted Rick at rvfilter and he was...

I had this issue with a 2010 and HL helped me get it fixed and have not had any more issues with it---they actually removed part of the upper skin and put in horizonal braces. al

I have not replaced my black, but did do my gray tank (the one below your black tank). If you want to save some time on labor, I think?? the gray tank has to come out in order to get to the black--if this is the case?? you could remove the gray---not a big job as I had someone help me and we did...

Hi everyone, I have a 2010 BH--3670 and the gray tank (shower) sags down a lot. I removed the coloplast and cchecked the straps and how they are attached all seems to be tight. However the angle iron that the straps connect to is really bending down toward the ground causing the whole tank to...

we lived in ME 35 yrs before going full time. It will be busy that time of year.. Not sure if you want ocean (Bar Harbor area) or mountains (Greenville area)---I 95 is an easy road as is US 2.. Let me know if something specific and I can help you out. al

An easy job, just takes a little time. There is a screw at each end, take those out, cut a new piece, I then used the old one for exact location of the screw holes and drilled the holes in the new seal---made it easier to get the screw into the existing hole. I did all mine, top, sides on our BH...