Search results

Put e-rated tire on it in January. Cost was just $806.00 for all four Mounted Balanced ready for travel.LOL

Donvnn I am planning a trip to Highland, MI next summer. Are ya'll near there or can you recommend some camp grounds. From I have been abel to find since the harsh winters up there, there are not alot of full hook up camp grounds...

Dale and Jen, Kenda Karrier tiers have failed on my 06 3055 twice. Just being parked I saw the bubble. Kenda was not easy to work with but did adjust. It took them 6 months and lots of calls. I just broke down after the second bubble and replaced all four with G/Y Marathon tires. I feel...

I just want to extend a public thanx to the Heartland Family and especially Jim Fenner, who took it upon himself to insure my problems (the few I have had) were taken care of...To him I give a personal at-a-boy and very sincere and heartfelt thanx.....Frank:D

Jim, We have never been to a rally before. Although we are not full timers yet, I do have a yougster(16) to bring along. Would that be ok or is this strickly an adult thing. I have not made any of these yet but would really like to get with other Heartland Owners. I did not see a cost yet...

I had the same problem with mine last year. When I looked at the plug I found the plug had burned. Wires were not tightened as they should have been and shorted. I posted that last January. Heartland/dealer was quick to fix problem for me. So if you haven't already, check the plug where the...

You know I was asking the same question about a year ago and found an article, I beleive it was in the Highways Magizine. It covered the wind turn over amount for a 30' 10,000 lbs 5th wheel. If I remember correctly and the figure I have used since is ...ta..da......85mph. The article was...

CMART I just put 4 GY Marathons on my 3055....Went ahead and balanced them as well all said and done OTD was $806.00 with replacement. Anyway I purchased through Discount Tires and paid about $157.oo P/T.....what a ride..........

I have a question. I am replacing my Kenda Tires ASAP and have found the Goodyear Marathons 10 ply E rated tire are the ones. My question is the same E rating on the current Kenda tires are inflatable to 90psi yet the same size and rating on the Goodyear are inflatable to only 80 psi. Is...

I think I can chime in here now. Once again I have another tire failure with the Karrier tires. This summer I found a baseball size bubble on the outside wall of the left rear tire. Kenda (Roger) was helpful but would did not pay to replace a tire that was a year old and had less than 4000...

Your gonna need a lug wrench or impact socket. I broke a regular socket. Impact wrenches are to much for regular sockets. Anyway be careful finding a thin wall socket. Just got back from returning another socket to pep boys. Thin wall but just won't fit. If u come up with one, please post...

Yup been there. I guess I will be at the grinder again......Did that with the single lug wrench. Thanx for imput guys.....I wonder who thought about the lug holes when they designed those wheels....oh well they look good....:cool:

Just a regular impact socket?...I took 1 back to Sears because it just wouldn't fit. I will try SnapOn....I forgot about those guys....Thanx....

I have a question regarding the wheels on my 06 3055. I have had to change a tire and found that no impact wrench socket, 4 way lug wrench or single lug wrench fit inside the lug hole. I had to find a single wheel lug wrench and file down the end to fit in the hole. This still presents a...

I just found the bed roller wheels on the slide broke, again.....and now the left side of the bed frame nearest the doorway has fell or broke. I think the rollers have something to do about it. Anyway. I lifted the bed and cannot see how to lift the frame back up over the metal part holding...

That is the plan this weekend..thanx....I'll see what happens, for all my ability I might be in the heat for awhile...

I found the photos when I did a search for the vent in the tent...the photos really do not show much...that's why I still need help.....I know there are a couple somewhere else on the website but I couldn't find them.

Thanx Chopperbill, your talking my language...BEER....If it saves cash then I'm in...the project for this weekend.....thanx..I also brought up some old photos and printed them...I hope I can figure it out without breaking anything....

I must really be an idiot because I don't understand how to do the tent in the vent thing. I sure want to get the cooling that you report, but my limited mechanical ability keeps me from trying. I saw some pics posted but could not figure it out. Is there a SIMPLE directive out there for us...

I did call Roger and found his plate full. He told me he would start the claim when I provided him the info. He also told me he was way behind so I don't know how long it will take.

Scott, Your right I was out of line...and I do apologize to you and Heartland for that..But I got a response, which was what I was looking for. You and your staff have been very helpful to me and again it does not get mentioned enough so again I apologize. That being said I will call the...

Well I guess when it comes to tires, we should all be aware that it is LOW BID and good luck......I can't even get the tire manufacturer to e-mail me and give a dealer in my area!

Well as I have reported before in the forum, I thought because I didn't see the problems first hand I was exempt. Well I have toilet problems too. The water, good or bad, seems to seep out the bottom of the fitting to the floor. That's right I said to the floor. I have pulled it up resealed...

Can anyone at the factory advise me how to get a tire adjusted in San Antonio, Texas? I found a baseball sized bubble on the outside sidewall of a tire that has less than 6,000 miles on it. I have searched the internet for these tires and found no local distributor. I also had to purchase a tire...

I sent him an E-mail Scott, thanx..

Scott, I had advised my dealer to fix the outside bottom of the bedroom slide while under warranty because it as coming off. The solution was to run rails on each side to keep the bottom from coming loose. Well this fix has created the rollers breaking off under the slide and a metal to...

Ken, Ok that did it...I am not sure exactly what I did but I got the spring loaded vent cap and so far so good. Thanx for all the great ideas....I did most of them and tried the least expensive, so thanx again Ken....No Smell For Now!!!

Well I have checked all those great ideas...No go..All the screws, vents, pea traps and pipes are good. No visiable leaks.....At wits end with this. The wife is getting upset at me for the smell not being fixed. Since living in this for the last month we were doing good, but...

Get used to it..I have lost 4 of them over the year or so we have had the B/H....dealer won't supply me any more...but they keep falling off from under the step. I have used silicone, superglue and expoxy. Nothing seems to keep the thing on.....I have bought a supply of four extra the last...

Thanx for replies...Pulltab, I will start checking what you are talking about as soon as I leave work...I'll let ya'll know if I found anything.....Wish I was at the rally.....We are planning on it next year...

We are currently living full time in our B/H 3055. I have had it for just over a year and had been doing summer and weekend type camping. Building a house now so here we are and I am now encountering some of the problems I thought I had been exempt from.. My problem now is sewer smell when the...

Great pics....just spoke with the wife and are REALLY attempting to put aside those dates for the rally....We have never attended something like that but have been to Branson and have to head that direction to Michigan for a visit. dates are just in line.....

Photos Hi Jim, When are you going to post some photos of the ralley. Those of us who were unable to attend would like to se what was missed. Thanx..Frank

For the rollers you have to pretzel yourself in between the slide, while it is pulled in and the wall.....not much room there and with my bifocals not very easy....When bringing in the slide be sure someone is lifting on the outside. I have been unable to get back there to get the roller screws...

yup...sorry Jim these conversations begin one way and end up being something completely different.....

Well guys I got tell you. We are building a house and have moved into our 2006 3055 that went out of warranty in April. Since we were weekend campers and summertime users, I just didn;t see some of this, but I was awakened receitly when the roller under the bedroom slide fell off. The screws...

Thanx.....I will try to pretzel myself in there!!!

coley, Can I buy a factory extended warranty? How can I do this?..Thanx Frank.....3055 owner...

Thanx...I see the roller problem has appeared before...my biggist problem is I have a heard time seeing up under the slide to replace the screws that broke off......It seems I am finding more of these srews everywhere!!!!..I am not a great mechanic...but it seems I am becoming one....Can anyone...

Has anyone had the problem of screw heads breaking off.....Once again, now out of warrenty...I keep have the screw heads breaking...The roller on the bedroom slide just broke off all four screw heads, fell off...Any specific screw I should use and how long.....Just like the screws on the closet...