Search results

Thank you for the input. My generator however runs fine standing still. It just won’t stay running while towing it down the road.

We have a 2015 Cyclone 4200 and wish to run the generator on hot days while towing to keep the trailer cooled down. The generator will not run long. We had a 2011 cyclone with the same generator I believe it always would run fine while towing. Does anyone know if it is designed to be able to...

Thank you for sharing. My welder last night boxed the open sides of the bracket. He comment that he felt they were excessively long especially for how they were made.

Ti also appears to be the rear Rt hanger correct?

Thanks for all the insight. I'm just a little baffled because I have had the trailer for 2 1/2 years and 15-20K miles. I put Carlisle tires on it the week I bought it. the tires still have about 50% of their tread with no sidewall or wheel damage evident. Luckily I backed the trailer in the shop...

Its still welded to the frame. It is a 3 sided bracket and both sides snapped off at the 90 degree bends

I have a 2015 cyclone 4200 Tri-axle that has a broken rear leaf spring hanger on the right rear. It has broken completely off the frame. I am trying to find out if this is a common occurrence.

Ever since my patio started getting soft I put a tarp over it which looked like you know what. last fall I bought a sheet of rubber roofing material and installed snaps on it and around the perimeter of the deck. I leave it snapped on all the times so I can leave the patio down and is does not...

I have contacted heartland. They say they are unaware of any issues with the doors (shocking) but they will forward any pictures I send them to Lippert for consideration. There is only a one year warranty on the doors and my unit will be 2 years old June 23rd. Was your trailer less than a year...

Thank you for your input. my unit is almost 2 years old, but I will contact the factory

May rear ramp door anti skip material has split up the middle. it appears there is a seam in the sub flooring that is moving even when it is only walked on. I'm not sure what to do to correct it has anyone experienced this problem and found a good fix?

I'm thinking its the control unit. But I have a limited amount of knowledge when it comes to this type of system. Lippert will be hearing from me tomorrow for sure. thanks

I appreciate the suggestions. However I have turned the power to the control unit on and off and have reset the zero calibration several times. i still get the same results. When pushing the auto level button out of the 4 stabilizing jacks I only get one or two that contact the ground before it...

i called them today. they said to to reset the level which I did with no improvement. I will try again tomorrow.

I have done the 10 up & 10 down. i have not tried resetting the the controller. i will give that a try tomorrow. Do you have to reset the level with the 10 & 10 again after the power is reconected?

I have 2015 Cyclone 4200. When pushing the automatic level button the jacks do not all make contact with the ground any longer but the controller beeps and says it is level. I have leveled it manually and reset the zero calibration but it still does the same thing. It will put all the jacks down...