Search results

I installed blue rope lights with the same type of plastic cable clamps using the factory coroplast self tapping screws as you did. Its been going on 4yrs now and they still work and are in position.

I seem to remember about a recall for a cooling fan issue but dont know what the specifics were othe than it was on older ones.

I agree, doesn’t look like a tapered thread to me either.

Re: Mystery Switch Pull the switch out and see if its even connected to anything. Wouldn’t surprise me if it wasn’t. 😂

No Problem

If i were u i would stick with the coleman then. Ive had my brisk 2 replaced three times now, hopefully they’ve finally fixed the underlying cause but i dont think if i were in you’re position I’d take a chance.

Yes it is, hopefully this one will last more than a few months.

Would you stop for fuel please, you’re making me nervous .😬 Lol

Lippert gave me the part #236575 300:1 ratio motors. I purchased two new ones on Ebay and will then keep the one good one i have left over for a spare. I attached a photo of the old ones in case anyone else has the same ones.

Lippert might be my best bet then. I just want to make sure i get the correct one. If a replacement can be had for $100 or under i will likely replace both as i dont really want to run into this problem with the opposite side, that’s usually my luck. I can clearly see that the bad motor is...

Hello everyone, got the Sundance out of storage yesterday. Everything worked as it should except for the bedroom slide. One side wouldn’t come out of the wardrobe slide. After troubleshooting I determined the motor on the right side was shot. I removed motor and it was all corroded and rusty. My...

LT Evans eatery and drafthouse in Danville is great.

Ahh yes, i was speaking of 14... 414 from watkins glenn goes through Hector and Ovid on the other side of the lake. I have been that way numerous times to Waterloo. You shouldnt have any problems, tightest spot will probably be turing off main street in Watkins glenn.

Wide open from Watkins glenn all the way to Geneva. Travel it often. There’s multiple spots you could meet others. Tour buses travel it everyday

Our Sundance does the same except the furnace doesn’t affect it. Following!

Re: Bh 3950 fl Yes! I’m not a fan of the half bath. Storage is vital.

Active volunteer firefighter. Have been a lieutenant, captain, assistant chief and back to lieutenant when we had the baby last year, been at it for 20yrs. Not nearly as active as i was but priority’s change. Still love it though when i can.

We’ve had a Sundance XLT for a few years now and loved it, We are in the process of buying a new some other brand one but only because the floorplan no longer fits our needs and theres nothing in a Heartland that fits. I would absolutely buy another though if they had the right floorplan.

On my Sundance XLT that has no auto level the JT strongarms and x chocks make a remarkable difference. I used nothing for a few years until a friend got a new fiver with strongarms and i could see the difference. It was money well spent IMO, and i will spend it again when we pick up our new...

Get a set of JT strongarms instead https://www.lci1.com/jt-strong-arm. I installed a set from Etrailer.com last year and think they made a remarkable difference combined with my x-chocks. Higly recommend.

Our dealer tried to sell us on one of those coatings also. If I’m remembering right it was a grand or more. We opted to not have it applied. Friends bought a TT around a year later and purchased the coating package. I’ve always questioned if they ever applied it, we’ve been camping next to them...

Thats still something we are going to try and make for sure.

We’ve picked our replacement fifth wheel and unfortunately its not a Heartland. We chose a GD reflection, after looking at both finalists its the perfect fit and very nicely built. I have nothing bad to say about Heartland or our sundance it has served us well. Thanks to everyone on this forum...

I keep my fiver plugged in while at home so I never shut my fridge off, it runs off propane when traveling and usually gets plugged in while using camper, just make sure and keep the drain hole free of ice buildup.

The yuengling brewery is really cool definitely worth a tour.

That would indicate to me that the hot water heater isn’t bypassed and all you’re antifreeze is being directed to the tank and just running out the drain plug. There should be three valves at the back of the heater that need switched as indicated in the other posts.

I was told by my dealer that if you plan on storing your RV outside not under roof that you should just inspect the roof and repair any questionable spots in the fall and nothing else. They said NOT to use an rv cover that they do more harm than good.

I'm guessing a 2010 would've been a "hard" switched heater and your new 2017 is integrated into the Sync 3 system so maybe thats the issue. Just a thought though.

Sweet, i pay over a hundred bucks a month to store mine. In a few years I’m going to take that money and build a pole barn to pit it in. Something very similar to what you’re doinf less the heat.

This forum is an absolute gem and will still be lurking around I’ve gotten so much good advice here but after having our daughter we are searching for a bunkhouse floorplan and We’ve looked at every bunkhouse fifth wheel in our budget in the Heartland arsenal and neither my wife or I really like...

Do you photo your slides every trip, boy i thought i was bad 😂

Re: Considering 2018 F450 Lariat Ultimate Jim, I have X plan through my employer and have no plans on purchasing anything this year so my two pins are available.

X2.... The front cap on my sundance was leaking also, through advice on this forum i tracked it down to the top marker lights. Used some black silicone caulk around them and haven’t had a problem since.

How bout it. Years ago you just showed up at your favorite campground, now ive gotta book weeks in advance and hope the weather works out.

I put them on my sundance this spring, towed the fiver around all summer with zero issues.

Luckily GM engineering hit a homerun with the bumper steps in the newer trucks or I'd be buying the tailgate step also. Im 5'11" and with these new big trucks i cant even reach in the back! You'd think things like retractable steps would come standard on 3/4 ton and bigger trucks. If this...

Awesome job! I love tinkering on stuff like that, unfortunately my 8 month old baby girl has me doing other things these days, haha ☺️. Cant wait until i can get some more shop time to do them again.

Haha, right. I dont have a spacebook account nor will i ever if i have my way. Far as I'm concerned its the devil. Lol

Thats exactly what i orderrd. After watching some YouTube vids and reading some reviews i opted for the bestop step instead of Amp but both were very similar.

I just ordered the step from etrailer. Guess I'll find out first hand how its going to be, lol.