I have been battling the inadequate single power landing gear problem on my Cyclone for a few years now. I finally bit the $400 bullet and ordered the dual power conversion kit from venture mfg. The parts arrived today and as I began removing the original parts I noticed something that didnt seem quite right. The legs have two protrusions on the outboard side that catch on brackets welded to the frame with pinch clamps to hold them in place. On mine, the upper brackets are too low so the protrusion is above the bracket. All of the weight is being put on only the lower bracket and it is bending it up at the weld point. I'm pretty sure that this is wrong. Has anyone seen this before? Its a 2007 so my warranty is long expired, but this seems like a pretty serious a manufacturing defect. My first thought is to grind the upper bracket off and weld it back on a few inches higher.