Nightshifter
Active Member
Modifications
I removed the frame with the back light on the rear of the dinette slide. Then I built this wall shelf and got a valance from the parts department to match the one on the front dinette window. I used the 12 volt power supply from the old led back light an installed two double usb charge stations and a voltmeter. Now the I pads and the cell phones have a home. Also any papers etc that you get from the office at the campgrounds.
I also installed a new led step light with motion detection and a switch to control the same.
I ran a temp sensor down into the under belly to monitor the temperature below during colder weather. Added heat mats and tape on the tanks and water line. My own yeti package. Will hook all the yeti mats up after our trip to Florida
I removed the frame with the back light on the rear of the dinette slide. Then I built this wall shelf and got a valance from the parts department to match the one on the front dinette window. I used the 12 volt power supply from the old led back light an installed two double usb charge stations and a voltmeter. Now the I pads and the cell phones have a home. Also any papers etc that you get from the office at the campgrounds.
I also installed a new led step light with motion detection and a switch to control the same.
I ran a temp sensor down into the under belly to monitor the temperature below during colder weather. Added heat mats and tape on the tanks and water line. My own yeti package. Will hook all the yeti mats up after our trip to Florida