Just took possession of a 2011 NT 32 BUDS. I noticed that the inside tv is off-level...slightly (1/2"), but enough to be a nuisance. I removed the back panel to see if I could make an adjustment, and noticed that only 3 of the 4 bolts/screws were installed. One of these 3 was cross-threaded so bad that I couldn't get it out with a normal screwdriver. I don't want to keep going at this screw and round it out so much that it will have to be cut out. Any ideas on how to remove this cross-threaded screw?
QA, are you tuned in to this?
Any advice is appreciated.
QA, are you tuned in to this?
Any advice is appreciated.