imchud
Well-known member
Hey Jim,
can you check to see what I could or should do about this with the factory........
Any ideas on my main slide water problem?? Mine leaks on the main slide, it soaks the carpet that runs under the slide from the front corner by the Frig, back about 4 to 5 feet to the front of the table and chairs... But mine only happens when the slide is closed, and it can't be from the tires kicking up rain because it was parked... It's wierd because it didn't do it all summer and now the last few times it rained and we open the slides the carpet was wet?? There is a 3/4" gap on the front side of the slide and on the back side you can't even get your fingers between the slide and wall. One of the problems is our dealer is out of business (Jim May) and we have it at a local general RV repair shop oked by Heartland. They told me the seals as far as they could see looked great, but now it back at their shop because it leaked again. I think the main slide may need adjusting but I'm thinking the factory may need to do it, to insure it's done correctly, what do you think?
can you check to see what I could or should do about this with the factory........
Any ideas on my main slide water problem?? Mine leaks on the main slide, it soaks the carpet that runs under the slide from the front corner by the Frig, back about 4 to 5 feet to the front of the table and chairs... But mine only happens when the slide is closed, and it can't be from the tires kicking up rain because it was parked... It's wierd because it didn't do it all summer and now the last few times it rained and we open the slides the carpet was wet?? There is a 3/4" gap on the front side of the slide and on the back side you can't even get your fingers between the slide and wall. One of the problems is our dealer is out of business (Jim May) and we have it at a local general RV repair shop oked by Heartland. They told me the seals as far as they could see looked great, but now it back at their shop because it leaked again. I think the main slide may need adjusting but I'm thinking the factory may need to do it, to insure it's done correctly, what do you think?