Search results

Here is a picture that shows pin designations. You should have only one +12 volt pin and one neutral (-). Peace Dave

Cheap Heat shares the same fan as the LP furnace so it doesn't sound like a fan problem. Clicking indicates that the furnace is trying to ignite but may not be getting lP gas so it shuts down. I would investigate lP flow. Tanks full? Flame on stove? Water heater work on lP? Just a couple...

Here is a link to a pair on eBay. Link Peace Dave

Seals came from eBay. Look HERE. Different lengths and widths available. Seller was recprousa in Elkhart IN. Peace Dave

FYI this thread is 11 years old. :) Peace Dave

My daughter had a similar seal failure on her SOB. I did a little measuring and was able to find some straight seals that had sticky tape on them. The wiper seals come in different sizes. I cleaned the frame with alcohol and stuck the new wiper seals on. Still holding up well. Peace Dave

This for sale thread is closed per forum rules. Interested parties can request photos by email. Peace Dave

Re: interior light switch? Or it could be ceiling lights in that slide. Do you have lights in that slide? Peace Dave

I don't think you will have a problem locating parts. Most likely what you need is a rubber gasket or just some plumbers putty. Take it apart and replace what you think needs replacing. I've replaced my entire vessel sink. Residential sink was the same as the RV sink. Peace Dave

I would not use silicone. It's hard to remove if needed and nothing will stick to it. Peace Dave

It sounds like one of two things. Could be a loose ground wire. Locate the grounding block and check all the screws holding the white wires in place. Check the battery wires as well, they need to be clean and tight It could also be your converter trying to charge a bad battery. Or a dying...

I just looked at a Pioneer brochure and it states a fully walkable roof. Didn't state the roofing material but I'm gonna guess EPDM rubber. If your used rig has not been maintained then you can expect some leaks or water damage. It's recommended by Heartland to check often. If your leak is at a...

There are a bunch on eBay. You might find one that fits. Peace Dave

Mmm yes, and they serve Spamples. And while your there go to Culvers for a Spamburger. Peace Dave

Is this the Gen-Y Hitch you are looking at? Peace Dave

It would be great if you were to post a picture of the separation. Peace Dave

If you've had issues with the roof in that same area I suspect that water has caused some damage to the wood in that area and now the screws that hold the front cap on have nothing to bite into. Or the screws are rusted off. Peace Dave

Check for a yellow sticker on the entry door jamb. You might find the VIN there. Peace Dave

This for sale thread is closed per forum rules. Please let us know when this is s sold. Peace Dave

It's normal for a slide (one without rollers) to be cantilevered when it is retracted. It's not normal for the floor to detach from the wall. Peace Dave

Hmm, it sounds interesting but I can think of a few reasons I would not heat with wood. My concerns would that it could be a tripping hazard in an already small living space, the use of foam and plastics and other combustible items used in our campers, potential burn holes in the EPDM roof and...

The thermostat should be set to the temperature you want it to open at. So if you want it to open just move the little temperature set lever a little bit and wait a few seconds for the vent to open. If you move the set lever to 90° it will not open unless the ambient temperature of 90°. You...

Menthol Hydrate known as, among other names, methanol or in the automotive world it's Heet. Peace Dave

Wow E, that looks like a great upgrade. Thanks for sharing your detailed install. Peace Dave

I think your best shot at finding that cupholder would be to contact LCI1. 574-537-8900 I checked their website but didn't find that style listed. We have that same style. That cupholder/control is not cheap. Peace Dave

Check out this recent thread. I might be offer some information.

Looks like you did a really nice install. Peace Dave

I gotta ask, are you using some sort of whole RV electrical protection such as a Progressive Industries EMS? You may have had a spike or brown out. Either way without it that might have caused damage to your AC. Just another thought. Peace Dave

Pipes, hose, tubing is purchased by the ID. 1/2" PEX is normally used in the RV world. Sharkbite for 1/2" PEX will work. Peace Dave

Along with what Dan said I noticed a yellow flex line. I don't think that's OEM. Is that the line that feeds the stove? Peace Dave

For ease of vacuuming you can remove the screws that hold the table to the floor, if they have now already been removed. Just four screws. Also a many people have removed the table completely and replaced it with a smaller version or a desk. Plenty of options. Oh, and welcome to this great...

Since you are there you might as well just change the ATF and add a quart of Caterpillar antistiction. You will only get the ATF out if the reservoir. Peace Dave

Have you checked the lug nuts? I would then suggest checking the springs, hangers and bearings. Peace Dave

I understand the heaving but the hydraulic legs are self equalizing so it shouldn't matter. At least to me it wouldn't matter. What ever anyone is comfortable with will work. Peace Dave

There are a couple of things that might have happened. You might have broken a part on the rack and pinion system such as a tooth on the gear or a pin or small bolt on the shaft. You might also have broken a weld on a place like the hydraulic ram mount. If your handy it might be a DIY project...

I don't know why the rear legs can't be left extended for storage. The front landing gear legs are extended. Peace Dave

You can storr your RV anyway you want. Legs up, legs down. It don't matter. Peace Dave

It sounds like you have power if you are trying to run a heat strip. My suggestion is to get one out two 1500 watt electric space heaters. We have Pelonis brand, they work well and are quite small. Peace Dave

It's not uncommon for a person's rig to sit on the dealers lot for months while waiting on repairs. Unfortunately. Peace Dave

There are several YouTube videos here. Might be off some help. Peace Dave