Search results

It's a nitrogen..... blend. Peace Dave

That would be #2 square bit. Peace Dave

Since that is a 2019 model it was most likely built in 2018 so it likely sat on the dealers lot for two years. That's two years with no maintenance. If you're seeing insulation there's a good chance water has made its way in. I'll set your permissions to allow posting pics in just a few minutes...

I think that if your wife can hear the magnets buzzing your brake controller is sending a signal. Have you inspected the brakes for possible grease on the shoes? Peace Dave

Kinda hard to tell what I'm looking at in your picture. When you say pull the rubber back are you talking about the rubber roof membrane or the rubber writer seal? Try taking the picture from a little more distance. Peace Dave

Re: 2021 Goshen Rally - Discussion Thread I like the way you think. Lol Peace Dave

Nice! Peace Dave

You could try calling Heartland Customer Service and ask about getting a door. However I don't think they stock cabinet doors. But maybe. If you call be sure to have the last eight digits of your VIN handy. 574-262-8030 You might be able to get a door at a big box building center such as Home...

Wires for the tail lights should be inside the frame so I think that the lack of tail lights might be coincidental. Have you checked intside that flex wire chase that I see in your pics? Have you checked all 12 volt items in that slide? Refrigerator included. If your tail lights are out are you...

Been down so long I was starting to shake. I'm surprised they were not using a RAID system before now. Peace Dave

Did you try adjustng the fireplace thermostat, if it's equipped? Peace Dave

Lou, it's very important to have the mast that you will be using perfectly plum. As long as you are close, like on the same acre, you shouldn't have to change any settings. Pretty much plug and play. Once you are mounted you can verify the aiming by using the signal meter on your receiver...

There is a fuel rail pressure relief valve located on the end of a fuel rail. Once the relief valve has been activated it will continue to do its job but becomes weaker on every activation. Been down that road. The valve is inexpensive but a bugger to change. Peace Dave

Teresa, check out the Events tab in the tool bar above and check out the Wisconsin chapter rally in the Dells. Maybe you can fit it into your summer schedule. Peace Dave

If you can order off eBay, I've found a few there. Access doors. Well at least one. Peace Dave

The vinyl flooring in our rigs is not glued, only stapled at the perimeter. I think flex could be problematic for glued vinyl. But, if you want to glue it check with the manufacturer as to what they recommend for their product. Peace Dave

This thread is closed pre forum rules. Please let us know when when you sell the sign. Peace Dave

We have a WiFi thermostat at home and I love it. So as long as you have reliable WiFi at your campsite I see no downside. Peace Dave

I recently had a conversation with a friend that was looking at a new Cyclone and the deal killer for them was the location of the washer vs the half bath door was a no go for them. He questioned if anyone at Heartland read the memo. Decided to look at another brand. Peace Dave

Welcome to this great forum. It's normal to have slack in the cables of an electric slide. Many of us have adjusted a hydraulic slide. You can find instructions on how to do it by clicking on the Tools button above. Or by clicking here. Check out the link in my signature ance consider joining...

Well, I guess you could price the 21FX and the 23 FX then guesstimate a price somewhere in the middle. Peace Dave

Have you looked here? Peace Dave

If, you happened to hook up your new batteries incorrectly you will blow the fuses on the converter. When you find the converter check the fuses. Peace Dave

Those are questions for the Australian authorities. I suggest a call there. Peace Dave

My previous truck cought that box on my last Bighorn. Like you I moved the box. Peace Dave

Re: Forever outside light... Hello Cannondragger and welcome to this great forum. Lots of great people here with plenty of knowledge to share. Hopefully someone with a similar model will chime in with an answer for you. Peace Dave

For us, plates, bowls and coffee cups and mugs just get stacked in the overhead cabinet. Wine glasses get wrapped in paper towels. Peace Dave

I'm with Lyle, I've had them sticking up for ten years now. No problems yet. Peace Dave

We're in, site #6. Peace Dave

Hello Johny_Dough and welcome to this great forum. Lots of great info to be found here. There is no model specific manual. Only the generic one size fits all. But with all of the experienced owners here if you have a specific question this is the place to get answers. Don't forget to join the...

There ya go. Mike is a refrigeration guy so I would trust what he has to say. One thing he didn't mention is that he told me the freezer rocks at -3 but the refrigerator box won't settle down. Peace Dave

He will reply here personally. Peace Dave

I have a friend that did that conversion. I'll check with him to see how it's doing and report back here later today. Peace Dave

Re: Tail light or flasher replaccement Looks like you need to spell check your spell checker. :) Peace Dave

I have never heard of a break in the Romex wiring going to an AC unit. Seems odd that you have had a break in wiring to two AC units. Peace Dave

You will never stop those critters. If you get rid of the current vandals it won't be long before a new group moves in. I've had a bunch that have died of lead poisoning only to be replaced a few months later. They breed often so there is no shortage of replacements. And I doubt they will harm...

Actually I am in the middle of repairing rotted floors in my daughter's camper slides. The first thing you need to do is identify and caulk the source of the water leak. The previous owner may have already done that. Then make sure that the rotted wood area is completely dry. Purchase some...

If your going to disconnect a terminal be sure you do the neutral (-). Sparks will fly and your wrench will get hot fast if it touches any metal attached to the frame while working on the positive (+) terminal. Peace Dave

I believe you have a BAL slide. Here is a link to some cables listed on eBay. Peace Dave

Are you talking about the LED lights that are embedded in the fascia of the slides? You might have to remove the fascia to repair that. Peace Dave