Byrd, I will be arriving on 20 Sep and setting things up for Grace. Due to a scheduling conflict I will not be there Thurs-Sun. If you could sign her up for the Dinner Theater and add two XL shirts we would appreciate it.
Thanks, Terry & Grace Vinson
Nathan & Byrd, Grace and I will be in site#147 and arriving the night of 21 Sep. Let us know if there is anything we can do to help out. See ya then if not sooner.
Terry Vinson
- - - Updated - - -
- - - Updated - - -
Chris, I just made my reservations and am sure there is room for more so...
Not sure of the setup on your Road Warrior. I have a Cyclone which came with a 50 inch tv on a fixed mount over the fireplace. Unfortunately, you could not access the back of the tv to plug in HDMI cables. There are two holes in the ledge above my fireplace which are accessed by removing the...
If you are over-filling the black tank then the water has two places to go, it will back up into the toilet since the seal is chocked open or into the roof vent for the black tank. If you have a joint in the roof vent it could be leaking from there into the underbelly. My guess is the water on...
Ken, Terry & Grace Vinson will be arriving Thurs PM and leaving Sunday. Have had reservations for a while but haven't been on the forum. What about golf, haven't seen any posts, is Tom coming?
Re: ATF: Cyclone - Electrical issue
Sounds like your 4100 is a 2014 or later. Not sure what is on the same circuit, however anything in the island with the sink should be on your gfci circuit. Check for a gfci outlet (mine is in the bathroom under the sink) and see if it needs to be reset.
I also use Google Earth. It allows you to zoom into potential sites and has a feature which allows you to measure the actual length of the site and in most cases you can see if there are trees or obstructions off the back of the site. It also allows users to post photos which you can click on...
Can't answer your concern since we don't have the level up on our 4100. I have considered adding it but I am not convinced the current setup allows the rear legs to extend far enough since they are normally going to be off the end of most campsite drives. Actually, I would like to have the...
We have USAA as well. When I initially called to insure the Cyclone they referred me to Progressive. I called them back and told them I had an issue with having my tow vehicle insured through them, the Cyclone through Progressive and the motorcycles in the toy hauler through USAA. They then...
Heading to Lake Seminole on the Florida/Georgia line for a couple of weeks. I have read the campground has a lot of ants so I am looking for words of wisdom and tips on how to keep them from moving in with us.
Thanks,
Terry & Grace
Upon finding the warranty info cards in my packet, I contacted Heartland Customer Service and was informed it was not necessary to complete the cards. Was told the factory incorporates the serial numbers of warranted items into a data base under the VIN. Recently had Dexter provide replacement...
Not looking myself but my son told me that Toyota is finally entering the 1 ton market with a combination of the Cummins diesel and Allison transmission.
Not all ST tires are rated for 65 MPH. After reading all the horror stories on this forum I replaced my OEM wheels and tires with 17.5" wheels and Sumitomo ST 727 tires. They are an all position rib with a 75 MPH rating. Not a cheap conversion but worth the peace of mind and I feel better not...
I went with 17.5" wheels and Sumitomo ST 727 ribs. A good quality medium duty tire rated at 4805 lbs with a 75 mph speed rating. Not a cheap conversion at $560 each (tire, wheel, taxes and shipping included). The diameter is actually smaller than the oem 16" setup which was important to me...
Try www.clarksvillervpark.com. They are right off the interstate at exit 1. After you exit turn left, cross over the interstate and make a left just past the Shell station onto Tylertown Road. The park is just ahead on your left. I have never stayed there since it is too close to home but...
We were told a removable carpet came with ours by the dealer. They looked "high and low" and never did find it, lol. We use a rubber backed area rug which covers from wall to wall and the front half of the garage. It folds up nicely when we haul the bikes.
Terry and Grace
GARAGE AREA
Plywood Garage Flooring 2 axle (2,500 lb.) Rated 3 axle (3,000 lb.) rated
This is taken directly from the Cyclone Features and Options page of the Heartland website. Hard to believe an 18' garage will only hold 2500lbs when a portion of the garage would surely be over the rear...
If you open the door for the outside fridge there are two screws (square drive heads) near the door opening that hold the left side panel in place. With the screws out the panel will swing toward the fridge and you can see under the steps. Was in there adding support for a tv mount the other day.
I also use Google Earth which allows you to measure the length of the campsite driveways and zoom in on satellite views to check for obstructions off the end of the drive that would get in the way of lowering the patio, unless you are in a heavily wooded campsite.
Buy some Polyethylene film tape and clean the door and locking bar. Then wipe both with alcohol and apply the tape to the door frame and locking bar where it contacts the door frame. I also placed it on the locking handles and brackets or anywhere else there is evidence of rubbing. It works for...
Note the 3rd "Features/Advantages" as advertised on Lippert's own website. So like many others I think it is the safest way, especially on uneven ground.
Re: Structural damage from flexing on 4100 King
Picked the unit up from the factory and have taken it on two weekend trips (about 750 mi total). No signs of anymore flexing as before. Shout out to Eric McDaniel and his crew for their timely response and quality work.
That is my intention Oscar and I already have the measurements. Our rig is currently at the factory for repairs of structural issues which caused excessive flexing and resulted in damage to the closets. I had asked them to check into replacing the bench seat with a full closet since they had to...
Not an engineer but I would have several concerns. First, if your desired setup increases the weight on the rear axle, (which you seem concerned about) in doing so it would decrease the weight on the other two axles and increase your pin weight. I would be concerned whether excessive stress...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.