Search results

Mine has an inverter for the fridge but I do not leave it on when plugged into shore power

Does anyone use the electric dump valves If so what problems have you had and would you use them again

Ok, now I understand. Thinking of replumbing with a manifold system and getting rid of all the fittings and choke points in the system.

Most of you probably know this but some may not. I had been having problems with gas powered tools lawn mower, etc.. to to a repair shop and ended up having to have carbs replaced on lawn mower and chainsaw. Culprit was ethanol fuel. I am able to buy non ethanol fuel $2.50 per gallon (yes)...

Just a suggestion, if you can find non ethanol gas use it. I’m in Tx and started using it for all my gas tools and wife’s car. The difference is amazing.

Thanks sorry I didn’t g,eat back sooner. What I am understanding is one line goes to the tank from the pump and that line both fills and draws from the tank. Thanks again.

I have a 2017 bighorn 3760 el. Fresh water system is fed through an anderson valve. What is the diagram from the A valve to the few tank and back through the pump into the fresh water system

Does anyone have a diagram or traced the wiring and made a diagram

These are pictures sent to me by the factory. This is for a 2017 3670EL Bighorn. It has a docking station, washer and dryer, and Anderson valve to direct water. It won’t be the same but may give you some help. This was sent to me from the factory. As far as the wiring it just a tangled...

Thank you. This is the best description of a rv electrical set up I’ve seen.

Re: Slides won’t retract Ok, I’ve not had to move my slides manually but there is a tool that came with my 2017 bighorn that lets you do it manually with a drill. On mine this is located in the front compartment on the off side of the trailer. I have had good luck shearching on YouTube for...

If it’s not water cooled then no.

First change your filter, next check the screens on your faucets. The leak at the fresh water connection could just be the rubber gasket in the hose. Hope this helps

Thanks for the input. I did go back out and do what you said and it worked. I think it was a combo of tired, hot and cranky hitch. I also re chocked my tires a little tighter. - - - Updated - - - My Reese was never like this. I do like this hitch because there is no chucking with it. On...

It should be run maybe every couple weeks for 15 to 20 minutes under load. If you are not going to use it before winterizing wait until you dewinterize then do a complete service, oil, plugs, and all filters. Run it then and check for proper voltage out put. Then run it under load and check...

Bryan, Tx., took my written test last Wed. And they set me up for my driving test today at 1400. Passed it so now I can do this legally. For those who may not know, you can take the written test one place and the driving test another. On both days I was the only one there for the driving...

I have a 2017 big horn. The floor is on joist about 1 1/2 in thick. The floor itself is about 1/2 in thick. I just remounted the basement bulkhead in mine but have not been through the basement floor. I’m not sure what the material is the floor is covered with. Hope this helps

To answer your last question; we looked for a floor plan that suited our lifestyle, then looked at different makes with that same basic plan then bought the one we most liked and as our budget allowed. Most of your family owned businesses have now been bought up by the Thor dynasty. When...

If you identify make and model number of each appliance, you can go online and find good manuals that describe how to and troubleshooting procedures. Hope this helps.

I just thought it would be good to creat a post that could be updated as we travel, and have no issues with anyone adding their stops, but I can' t tell you how to do that. This is just a start will edit and update later. Was inspired to do this after reading (someone looking for a stop on...

My opinion is the fenders crack because of flexing from vibration and flexing. What I intend to do is cut 1/4" plywood to fit inside the fenders and screw and glue it inside the fender. That should cut down on the flexing.

I just checked and I do have an outside vent and it is unlocked. I do have power and my wife had to actually turn it off after she heard the pop. I do appreciate the suggestions. The dealer actually referred me back to heartland so I'll give them a call tomorrow. thanks again

Wife was baking a cake. She thought the oven was taking a longer than usual time to preheat to 325, or thought she may not have heard the beep when preheat was complete. She cancelled out and turned the oven off then reset it and turned it back on to preheat waited 5 minutes then set the cake...

Thanks gary

Leaving Amarillo headed to creed, thinking about taking us 285 from Santa Fe to alamosa. Need info on road conditions on 285 and for the rig in my signature. See any problems.

Thanks dave for information b stark

I have a 2017 BH 3760 el. When I put the front jacks down the left one goes down and makes contact, takes some weight then there is a pop sound and the right jack goes down. Once the right jack starts down everything is good. Is this normal? The jacks are hydraulic.

Charlie263, I understand your frustration, as we had a similar problem with our crossroads cruiser bedroom slide, swinteck drive. Ours was in the shop six months not all at the same time. We just by chance ran into a service manager while shopping at an rv dealer in Longview, tx.. He set up...

I just received a hearty welcome to he forum a few days ago and would like to pass it on to you. We've not picked up our bighorn yet but will do so this coming Friday, so welcome to the forum and happy & healthy travels to you and yours.

I recommend Hayes RV, 5009 Judson Rd., Longview, TX.. After our cruiser spent 5 months at three different dealers one being where we bought it we made an appointment at Hayes RV and took it in. They had it for a month, but it had to be completely refloored and all the gear drives replaced...

Just a HELLO from the wife and I. Looking forward to sharing information and learning from the forum. We have just purchased a 2017 BH 3760EL and will pick it up the 7th of July. This is our fourth trailer since 1992. At my age I'm looking forward to the self leveling and electric roller for...