i ordered replacement fender trim pieces (2) for the left side. When I received the parts I received pieces for both left and right sides, which other than the additional cost is ok because I know I will need the right side eventually. The problem is that I believe the wrong parts were sent. On the left, the front part is too long and the rear part is too short. The rep in the parts department is telling me that they are the correct parts and that I need to cut the longer part and glue the cut piece to the shorter piece on the rear. There is no way that a typical RV owner can cut and glue these parts and end up with a reasonably good finish. I called the Service Tech rep who talked with his supervisor and confirmed that these are obviously the wrong parts, but the Parts Dept does not agree. To expect an RVer to cut and glue plastic parts which are inexpensive to produce is not a quality solution representative of Heartland. Where do I go from here?