The other side is exactly the same finish. When its all the way out the face trim remains a couple of inches off the wall. You can tell that it was designed to be out a bit because the bottom portion of the trim is right up tight agains the rugged part of the wall so it couldn't go out any further if it tried. I am thinking the same that most likely a plastic piece should have come on each side. I am hoping someone with the same model can verify if theirs is unfinished like this or has something covering the ruff unfinished board.
No the slide is all the way in.. What i meant is that when the slide is all the way out.. There is about a 1" gap between the facia of the slider and the wall. I suspect this 1" gap is normal since the slide at the bottom is as tight to the carpeted part of the wall as possible. The only concerns i have is whether any trim piece was missing from the side that might cover this rough edge or this is the way they are leaving the slide finished. Thanks..
