avvidclif
Well-known member
It seems my level-up system has gone stupid. After unhooking and pushing the auto-level button it will level front to rear. It then starts lowering the rear 4 jacks and if the rv is close to level it stops and shows Success. Sometimes 1 o r2 of the rear jacks are down to the ground and some halfway down. At no time is it grounding all 4 and then leveling as it should. The book says re-calibrate the level. Ok, tried that. First step turn on unit. Second step push the front button 10 times. Third push the rear button 10 times. Problem is when pushing the Front button it activates the front jacks which changes my level I have set to calibrate to.
When the problem first started about leveling last month I called Lippert. "OH, it's out of warranty you will have to buy another unit" A lot of help.
I think I remember reading on here or somewhere that I needed to reset the microprocessor in the main unit and that consisted of unplugging the connector with the single red wire on it for a minute and then reconnecting and calibrating the level.
Anyone confirm that? As it is I can manual level with no problems I would hate to mess it up worse.
When the problem first started about leveling last month I called Lippert. "OH, it's out of warranty you will have to buy another unit" A lot of help.
I think I remember reading on here or somewhere that I needed to reset the microprocessor in the main unit and that consisted of unplugging the connector with the single red wire on it for a minute and then reconnecting and calibrating the level.
Anyone confirm that? As it is I can manual level with no problems I would hate to mess it up worse.