Hi eveyone,I have read the lippert Manuel on slide adjustment, but still seem to be having a problem We have a 3670 and the problem is one side of the computer slide out. From the inside it is the right side of the slide--it is dragging on the rug. I loosened both sides (per instructions) and then loosened the adjustment bolt (lowering the outer edge of the slide)---did not seem to make a differance. I then took it back to the original position and tightend the adjustment bolt and it did not seem to make a differance. Perhaps I am not adjusting it enough (moving it only one turn of the bolt), but want to know which direction should I be turning it??Advice or other ideas on this are appreciated.al
Slide adj---turn up (tighten) or down (loosen)?
- Thread starter aatauses
- Start date
If you make your adjustments, move the adjusting bolt one or two faces then run the slide in and out a couple of times.
Always watching when the slide comes in or goes out to be sure that you did not over correct or go the wrong way.
Then tighten everything up and do a final test.
If the first adjustment didn't do the trick, make another adjustment till you get how you like it.
Peace
Dave
Always watching when the slide comes in or goes out to be sure that you did not over correct or go the wrong way.
Then tighten everything up and do a final test.
If the first adjustment didn't do the trick, make another adjustment till you get how you like it.
Peace
Dave
Similar threads
