Weather stripping shrinking

[schew]

Has anyone experienced or heard of this??
The weather stripping on the rear upper corners seemed to have shrunk and detached. Both ends seem to be attached so I cant simply pull/slide the stripping tight to reattach it to the curved section.

 

[2psnapod2]

Common occurrence. Order some new stuff on Amazon and fix it, easy enough!

Sent from my SM-G975U using Tapatalk

 

[uncledon]

I've had the same thing occur on the underside edge of my fifth wheel. That style of trim snaps into that track, but if it shrinks it will pull out. Yours has shrunk enough that you need to replace it now. It should pull out.

Sent from my SM-G900V using Tapatalk

 

[jmarnell]

Had a very similar issue on our Cyclone, but at the front under the nose. I just cut the strip at the very bottom and pulled it up so I could pop it back in at the curve. You hardly notice it is now slightly short at the bottom, and it has never popped out again. I think the factory just pulls them too tight so a little flexing makes them pop out of the channel.

 

[schew]

Do I need to worry about water penetration if i simply cut and slide the weather stripping up, exposing the bottom??
I guess I could dab silicone on top of the exposed screwheads?

 

[jmarnell]

Do I need to worry about water penetration if i simply cut and slide the weather stripping up, exposing the bottom??
I guess I could dab silicone on top of the exposed screwheads?

It looked to me like the plastic strips are mostly decorative to hide the screwheads so I wasn't worried about that. But a little silicone can't hurt!

 

[2psnapod2]

It is pretty inexpensive to buy new.

Sent from my SM-G975U using Tapatalk

 

[schew]

It is pretty inexpensive to buy new.

Sent from my SM-G975U using Tapatalk

Do you know what the correct name of this type of weather stripping is?

 

[2psnapod2]

JR Products 10061 Premium Vinyl Insert - Black, 1" x 50' https://www.amazon.com/dp/B002UC2PNQ/ref=cm_sw_r_cp_apa_i_58uMDbT8YPTT4


Sent from my SM-G975U using Tapatalk

 

[schew]

JR Products 10061 Premium Vinyl Insert - Black, 1" x 50' https://www.amazon.com/dp/B002UC2PNQ/ref=cm_sw_r_cp_apa_i_58uMDbT8YPTT4


Sent from my SM-G975U using Tapatalk

What a wonderful forum and members. Thank you so much!!

 

[JohnDar]

Measure the width of the existing vinyl strip before ordering. It comes in both 1” and 3/4”. My BH has both (white) on it.


Sent from my iPhone using Tapatalk

 

[rhodies1]

What a wonderful forum and members. Thank you so much!![/QUOT

It comes in 2 widths. 3/4 and 1 inch wide. Measure your track width to ensure you get the correct one .

 

[schew]

Ok, good to know!