Search results

Check this out. Aulick. Peace Dave

The slide does not have to be flush with the wall. As mentioned, you just need to be sure that the bulb seal is compressed. Peace Dave

You can test your theory by putting a baggie one the Studor vent and securing it with a rubber band, then turn on your vent. If you get no foul odor replace the Studor vent. If you still get the odor, keep looking. It is not uncommon to replace that air admittance vent. They are inexpensive and...

Although I don't have an Oakmont i have gleaned some info from other postings. It seems that your main thermostat is the only one that controls the heat. Your bedroom thermostat controls the front AC. Peace Dave

This for sale thread is closed. Please let us know when this is sold. Contact Eric through private conversation. Peace Dave

There is a procedure for burnishing your new brakes after replacing. Did you follow the recommended procedure? Peace Dave

Thanks for your input. The forum software is supposed to automatically purge old for sale threads. Although I haven't checked it recently I will now and see that it gets fixed, if possible using this forum software. I'm thinking that function may have gotten lost when we moved to the new XenForo...

I suggest that you contact an LP supplier and ask the questions about the generator requirements and your supply. Peace Dave

Is there a number missing in your reply from support? Your low pressure regulator should have 6 ounces of psi or 10.5 in. water column. Peace Dave

That quick connect provides a regulated LP supply. So if you genny requires a regulated supply you are good to go. If that jenny requires unreguated you will have to find a way to do that. I'm pretty sure that you can get a fitting that attaches to your LP tanks and allows both a regulated and...

There are a couple things you can do to track down that short, some already mentioned. You didn't mention if a fifth wheel or bumper pull. If a fifth wheel there is a junction box located behind the pin box. You can open that, disconnect the running light wire and check the umbilical cord for...

This for sale thread is closed per forum rules. Please let us know when this is sold. Peace Dave

You might also consider a piece of plywood spanning a couple of studs. Stained to match your woodwork it could be one more option that's stronger to screw in to than the flimsy Lauan type wall panel. The table would be away from the wall a bit but it's better than the table mount falling off the...

My daughter's camper had the same thing happen. Did a little measuring and bought the appropriate sized single stick on wiper, cut the torn wiper off, outside only, and stuck the new wiper to the outside of the camper. Been a solid repair for about three years now. I think she ordered the seals...

You might try one of the RV surplus places near Elkhart, IN for the wood trim and maybe the skylight. Bontrager's.....269-483-7017 Johnson's.......269-483-2249 Rainbow..........574-642-3316 Bontrager's would be my first call. Peace Dave

This for sale thread is closed per forum rules. Please let us know when this is sold. Peace Dave

There could be some splitters in play there. To save a bunch of time and frustration I would, and have, just run a new coax from the back of one of the four coax connectors you described to the area you intend to have your Spectrum router or modern. Peace Dave

This thread is closed per forum rules. Please let us know when this is sold. Peace Dave

Check your power source at the pedestal. Also if your shore cord plugs into your camper make sure that connection is secure. Peace Dave

As I'm reading this post my daughter called and I asked her your question. She said not worth it. They they wound up replacing part that was repaired with the epoxy and plan to do a replacement on another slide. Peace Dave

My daughter used that epoxy. It kinda worked. The wood has to be absolutely dry and you have to drill a bazillion little holes for it to soak in to the wood to be most effective. But it does work. Peace Dave

While I don't have your model RV I did have the issue of a narrow door opening. I wound up removing the door and striker side door jamb. This might help you. Peace Dave

It might be worth while to wrap the fittings of the water heater with toilet tissue. If there is a leaky fitting it will easily be identified. I doubt that the AC is causing the water pool. Check the gaskets on the refrigerator. If they are not selling properly condensation could be dropping...

Here is a link to info on the leveling system. It can be found in the Tools section located at the top of each forum page. You will find information that will help you. Peace Dave

Depending on what brand or model AC it will hang down about two or three inches. So as previously mentioned check how much room you have from the top of the slide to the ceiling when the slide is in. Peace Dave

Does your rig have a ceiling vent? If so that is where the second AC would go. Also, does your rig have a 50 amp shore cord? You will need a 50 amp service to run two ACs. However, there is a way to run a second AC without 50 amps. Peace Dave

Here's one on eBay. Trailer tire and wheels is a popular tire store. Contact them for more information to be sure you order correctly. Peace Dave

I would run antifreeze through the pump or at minimum remove the filter bowl to drain what water is left in the bowl. If you have a black tank flusher run some low pressure air through that. Peace Dave

Do you know the reason your slide goes only half way out? Obstruction, low battery voltage etc? Peace Dave

Turn the pump on and listen for the noise. Once the general location is found you might have to remove a panel, remove a drawer, look under the bed or nightstand or some other hiding spot. Keep looking, it's there somewhere. Peace Dave

I've moved your DC to DC charging post. If there is staff online it will be shown by clicking on the Home tab in the tool bar above. You can send a message there. Peace Dave

There is a 12 volt manual reset breaker located in the bank of red covered 12 volt breakers near the battery. You will have to feel for the tiny reset button on the side of that breaker. Press it. Peace Dave

Depending on the model year of your 3055RL the bypass valve could be located in the docking center located at the off door side compartment door. The water pump will be located behind that basement wall. The wall is removed by removing a few screws, a couple might be located in the docking...

It sounds like you may have a bent axle. Take it to a truck/trailer alignment shop. They should be able to help. Some shops here. Peace Dave

I would contact tree furniture company and make a claim on the couch. Just because the warranty is about to expire doesn't mean it's not covered today. You might think about contacting Heartland and ask about a claim now before your warranty expires. Peace Dave

You might try turning it on and listening for the pump noise. Peace Dave

The pic shows up on my end but here it is again. Peace Dave

Even if the fireplace is no longer available the heating/fan unit might be. Although these have changed over the years I was able to find one on eBay. Much cheaper than replacing the entire fireplace. Peace Dave

It sounds like your fan is set to high or low. You need to change the thermostat fan setting to Auto. Peace Dave

I did mine years ago. I used galvanized sheet metal that I cut from some heat duct material. Using a jack and a piece of 2x6 I raised the slide a bit. With a little caulk along the edges I slid the pieces in place. I had pre drilled small holes along the edges and used small stainless screws...