Search results

There wasn't anything specifically made for the Terry Classic. The go to seems to be the "Shade RV" product. Beyond that, it's best to visit your roof at least 2 times per year, and keep washed at least once, this keeps it white and reflective, and alerts you to any potential issues. I wash mine...

Looks like pleather separation. If you feel the 2023 cushions are the same, just capture a 2023 VIN number, and order them.

Usually,,,,,it's the driving resistors that fail, causing the LED to flicker, or go out. If it's a through hole solder type, and you are handy, htey can be fized, if it's an surface mount resistor, than it's a bit more difficult procedure.

If you are a 410A refrigerant system, which contains equal parts of R-32, and R-125, and you have had refrigerant loss, technically what's left in the system should be recovered before a new and complete charge is added. This is because neither refrigerant parts will leak out at the same amount...

There are many 1210's to chose from. https://techsupport.pdxrvwholesale.com/products-category/norcold-refrigerator/

I'd say if you had codes, then the fridge already suggested what was wrong. Things like poor thermistor connections, drifting resistance values, Etc can cause no cool or fault codes. https://techsupport.pdxrvwholesale.com/technical-service-manuals/norcold-1201lrim/

Get a hardwired surge protector in either 30, or 50 Amp, with the wired remote display. It will display the shore voltage avail to the camper, the amps you are using, line frequency, IE: 60H, and fault codes. It can be bypassed from the remote, there are no dog bone units outside, just plug in...

Post a pic of the existing magnetron, there are replacements based off the current magnetron data. Typically when you replace the magnetron, you should replace the diode, and capacitor. This assures the high volt side is in good health. ERP parts is the number one aftermarket supplier for...

Well, each appliance, and the TV came with it's original packaged manual, and or install information. The thumb drive (which is probably outdated by now) contained manufacture contact numbers, and some general information. I personally posted all the contents of the thumb drive on the facebook...

Actually a "dead short" is voltage to ground or neutral (same thing). The breakaway switch and it's branch circuit is a peripheral circuit energizes the electrical braking system exactly as the break controller would, with the exception that full 12 volts are supplied to the brakes instead of...

I get into a habit of checking my water heater, plumbing connections, and any electrical I can. That looks like a hand tight fitting on the outlet of the water heater, years of expansion and contraction will force a leak. My initial shakedown of my camper when purchased new revealed lots of...

Recourse for a warranty that's actually working to get the unit repaired? Sounds like everything is proceeding as it should.

A really good option that restoration body shops use is a good Rust Encapsulator. https://www.eastwood.com/eastwood-black-rust-encapsulator-paint-over-rust.html https://www.frost.co.uk/rust-converter-vs-rust-encapsulator/

I think the most important thing to note, that unless it's written in the contract terms, most likely not, you will not receive compensation for your down time, or loss of use of the RV, Camper, Etc., and will still be subject to whatever wait times to receive service, and duration of service...

⁉️ So there are many reviews 9.8/10, some stating 2, 3, 4 hours of cleaning time spent, 2 or more people, and almost all have job prices. A review 3 years ago for a 2 story to remove construction dust was priced out at 1,400.00. If you do the math, you have more than one person, and half a day...

WRONG,, there will only be change in build quality when consumers instigate that change...But we as a nation suffer from entitlement issues, and continue to buy these poorly made products, over and over again, accepting and fixing things ourselves, and keep moving forward complaining. My camper...

Micro Air is the way to go, I'm 2 years with mine.

Since I don't want to type this again, here is a link to a post I did here regarding cooling on a rooftop unit. https://heartlandowners.org/threads/a-c-freezing-and-making-ice.82286/#post-663232 Keep in mind that if you needed Freon, you most likely have a leak, as mentioned 410A is a blended...

What is the model # of your Sharp? Edit, I see it now...

The LG fridges that use the Linear compressor have a high compressor failure rate, a recent class action suit, which may be closed now supports this. Additionally Kenmore branded LG made fridges are affected too. LG branded usually have a 10 year on the compressor, while Kenmore have 1 year...

SO when an AC unit freezes up, there are several reasons. Low refrigerant, a low refrigerant charge will cause excess frost and some ice depending on how long it's been running. Usually the frost/ice pattern will encompass some of , or most of the coil, not all of it. A bad, misreading, or...

I have found, regardless of the definition for the red light being, "over current, or short circuit", that when the circuit is simply "open", like removing the fuse, or disconnecting the circuit wire from the screw terminal next to any fuse, you will get the red light. Maybe leave the USB out of...

more pics

Moved all future posts to the Facebook group, but wanted to add this one here. Maintenance time on the rooftop Dometic A/C yesteday. Looked it over a couple weeks ago, noticed both coils need to be cleaned. Decided to seize the moment to open the system up and do a proper evacuation, and...

I posted in my first year a very similar issue found at the shore cord to house wiring J box. Lack of enough stripped/exposed wire, and or lack of good wire to wire contact within the wire nut can cause this. Shorting connections can lead to heat can lead to your blackened and partial smoldered...

Not good, but at least the break away break cable and switch would be your last safety feature, should the chains function fail.

I've always said, use credit cards for everything you can. You at least can get consumer protection with them. My deposit was placed with a C/C, although a tiny percentage of the final cost, if a charge-back is successful, it will turn someones head. Alternately, when do people stand up?

Here is some basic chatter from other forums. https://www.forestriverforums.com/forums/f24/in-motion-lock-on-cherokee-total-control-226141.html https://www.mygrandrv.com/forum/showthread.php/36542-OneControl-In-Motion-Lock/page2?s=8966c4800d46e6a26aa9e34136136e89 This may be the trigger...

A nonsense reply to a 5 year old thread....

I was refraining from throwing them under the bus, but it's clear the live under the bus on their own.

The rocker switch on the heater it's self is for the 110V electric, it's a master disconnect.

Best to have your service center where it's at doccument, and take pics. Take that to heartland and see if they will reimburse.

Loose connections will do that, you should be able to cut the burned ends off, repair with new terminal connectors, or what ever was on there, re connect snugly, and be fine.

I smell a spam-bot in the room....

The black one seems to be in stock. Scrolling down shows the white one out of stock https://www.rvpartscountry.com/Atwood-31014-RV-Propane-Gas-Detector--12-Volt--Black_p_38526.html

You need your door interlock switches replaced. You'll have 3 or 4 in there, they act like a combination lock when the door is closed, often the one handling the most current will short due to the heat generated by the current flowing through it. Random High pointe video showing switch...

I order parts often, the 7953 number is the one i have used since 2019, till last month. Maybe yesterday's tornado near Indy has something to do.

The internal sensors will give you a more accurate internal temp reading too. https://heartlandowners.org/threads/a-running-list-of-corrections-mods.74358/page-4#post-657763

Doesn't completely make sense as your battery seems to be staying charged. Here is the "Manual" for your converter panel. You can look through some of the trouble shooting procedures and test as directed. As mentioned above you need to follow the trail of voltage from the battery to the...

Try wiggling the switch, applying light pressure on all sides of it, flick it on and off. I still have to address the poor wiring job from Heartland behind my control panel. Too many wires in too tight of a space (depth wise), causing pressure on the connectors, connections, and switches...