Search results

Traded the 2014 Big Horn. The nightmare has finally ended. Please remove me from this form. Good bye to all.

(4) 215/75R17.5 LRH Goodyear G114 tire mounted and balanced on 17.5x6.75 865 aluminum Lynx wheel withblack inlay, OP stainless steel center caps and 9/16stainless steel capped lug nuts. Have 800 miles on them. Cost 2600.00 will sell for 2000.00 Going to a MH Call 804-895-3833 I will let this...

Called Heartland and they said to put Caterpillar Hydraulic additive in system. Can not find any locally. Does anyone know where to purchase this type fluid.

Ordered three new slide toppers from camping world. Drove to Winchester Va to Camping World to have them installed. Manager came out to look at our 2014 Big Horn 3260 Elite and said you can't install slide toppers on two of the three slides. On the frig slide the vent for frig is to high to the...

Have 4 16" 8 hole

No comment now. I can say I doubt that I would buy one again.

Stains are deep brown that form from the oil in the compressor and freon. It's impossible to remove the stains without damaging the rubber roof. The one on mine has soaked in the roof, and could be into the ply board under the rubber. Dometic wanted to know if bubbles had appeared. No bubbles as...

New AC failed in two days. Went back to dealer and they said it was bad and the bedroom AC was also going bad. Both leaking oil and freon on roof. Bad stains on roof now and Heartland says not their problem. Dometic Brisk II front and back. Dealer said lots of problem in past year with these...

A\C was bad and dealer replaced it under warranty. Another trip had to be cancelled.

Just finish packing for trip and rear A\C quit cooling. Compressor running but no cold air. I'm not mad but I had enough.

Very dangerous, ours caught on fire. Dealer replaced ours.

Their is a switch in the control panel with all the other switches labeled awning outlet. I've had no problems with the speakers. If it's still under warranty call Heartland and they might send you one if you want yo install it yourself.

We received our new Lastingimpressionsform mattress today. We decided to get the 12" thick one with the 9" support base and 3" topper form. It came packaged in a box that about 1" x 6", It is amazing to watch it unfold when you cut the plastic seal off. Inside of 30 mins it was 12" thick. We...

I spelled it wrong should be Lastingimpressionsfoam.com

We are looking to change out our king size mattress in our Big Horn. Has anyone had any experience with a company called Lastingimpressionsfoam.com. We are looking at the 72 x 80 king 12" thick. They show it listed for 599.00 free shipping and 10% off that. Any pros or cons would be a great help.

I would like to apologize for my rant against Heartland. I realize that I had become bitter and angry because of the problems I've had. I ask all of you and Heartland to please forgive me, because I was wrong in the manner that I used this forum and the things I was saying.

I bought the Big Horn because of Heartland's reputation. A friend of our's had a Heartland RV and spoke very highly of them. I have found that Heartland looks out for #1 and will leave you setting on the side of the road. When our bedroom slide was out and would not come in I called Heartland...

Yes the dealer has replaced or repaired most all issue. Every time we have planned a trip we have had to come back home because of break downs. The unit has been at the dealership longer than we have been using it. When we leave on a trip we wonder what will happen this time. I have pleaded with...

It won't be a Heartland RV

Repairs in 9 months on our NEW 2014 Big Horn Vacuum cleaner replaced Fireplace replaced Kitchen drains leaking Bathroom drains leaking Sofa to close to wall and cut holes in wall Fiberglass sidewall cracked (4ft section cut out) Fiberglass sidewall cracked second time same place Awning pulled...

It does it full travel in and out.

The electric bedroom slide is making a noise when it goes in and out. Sounds like a chain jumping a sprocket. One of the cables on the outside is not tight like the other three. Still goes in and out but don't know for how long. Anyone have any ideas what might be wrong. You can' tree anything...

Washing Big Horn today and notice a stain on the side of the rubber roof. Looks brown like a pollen stain and it won't come off. I know you don't want to put anything to strong or it will damage the roof. Anyone have a way to clean the stain or should I just forget it.

I guess no one has install box springs and mattress in place of factory equip.

I'm wanting to replace our mattress in the Big Horn. The platform for the mattress is only ply board, and I was wondering if a box spring could be installed with rollers so it would slide in and out with the slide. If anyone has attempted this please chime in and let me know the results. Sounds...

I have 17 inch tires on my tv. On the door it says for front 55 psi light load, 60 psi max load. Rear says 60 psi light load and 65 max load, this a DRW. The tires say 80 psi max cold. Some of you are running 80 lbs in your tires when the truck door post says 65 lbs. What is the correct tire...

I have a Reese Pro 16 that's one year old. Email me rogerwalters1@me.com

The oil pressure goes up to 47 if you raise rpm just a little. While driving around 47 but after warm at idle it drops to 29 may be normal.

Just notice that the engine temp is around 203 just running around town without towing. Also ok pressure is at 29 at idle. This is the first Ram for me and was just wondering what other Ram owners temp and oil pressure run. This is a 2012 Ram 3500 6.7 2wd SLT

Today we purchased a 2012 Ram 3500 DRW 2WD. We looked at the 2014 but all of them were to high in the back because they were 4WD. We are happy with it and hope to get many miles of trouble free travel, if there is such a thing. Thanks for all the advice.

Been looking at the 2014 Ram Trademan 4x4 to tow my Big Horn. In looking at it the bed seems to be very high off the ground. Don't think it will work with my Big Horn. It would put the noise of the FW high in the front. If anyone is using the 2014 Ram 4x4 how are you working it? Thanks in...

Is the vacuum yellow. If so a blue relay is sticking. No repair unit, the factory will replace it.

A big thank you to Jim Beletti for contacting Heartland on my issue. I received a call today from Heartland and a lot of my questions were answered. Thank you again Jim for your help.

Yes, just what you said. They paid the dealer once to repair it. The dealer ask Heartland to send a tech there the first time to look at the problem, and they said no the dealer fix it. They found the problem on the first crack, frame studs broke. Second crack was in the same place but only...

Yes it was repaired after the second crack appeared. The issue is that the problem that caused the crack has not been repaired. The tech that repaired the unit said it will happen again. This is a season tech that all he does is frame and fiberglass work. The frame inside the walls is flexing...

Our's was checked when the first crack appeared. The dealer had some type of pressure device to determine if it had to much pressure on slide out. The problem with this unit is that the frame welds in the side wall are breaking, causing the side wall to crack. But as of now Heartland sees no...

We still have the Big Horn. When we went to take delivery of the new MH we found the salesman and tech standing by the MH. To make a long story short, water was running out of the front of the motor and they couldn't tell me where it was coming from. We were trying to get out of one problem not...

Found the model EC942KIW. Does anyone know where I can find a manual or phone number.

Can anyone who owns a 2014 3260 Elite tell me what model microwave/convection oven they have. Had a manual but the dealer burnt it up in the microwave. It' says High Pointe but can't seem to find the model # on it anywhere to download a manual.

I have heard some of you talking about replacing the clamps on hose clamp with other types of clamps. I am beginning to have a few leaks on my supply lines and it looks like where the clamps are. Can some one tell me my options on replacing the clamps with different ones if that's the best way...