Search results

One thing to keep in mind, by adding weight to the rear of the trailer, you will be removing weight from the tongue/pin. This is a simple teeter totter effect, with the axles being the fulcrum, ( pivot point ). If the axles were centered between the pin and rear bumper, when you add 300lbs to...

Check the GFIC in the kitchen

I installed a Reverse Osmosis drinking system I our Landmark. Plumbed a faucet it in on the kitchen sink and the ice maker.

The converter is operating properly. You have exceeded the output of the convertor. What you are experiencing is circuit overload. On then off, on then off. That is a circuit breaker tripping and resetting. Depending on the size of the convertor, it is possible to have enough stuff on to...

Without a disconnect, the parasitic draw is greater than the output of the battery tenders. In other words, the tenders cannot keep up and the parasitic draws win. If you have power to plug the battery tender in, you should be plugging the coach in instead.

A good curtain will help insulate it from the living space. We noticed, if you just lower the shade, helps tremendously.

I would suspect the battery. Possibly poor or loose connections.

Cold air falling from the window. Happens with all windows, even dual pane, worse with single. Windows offer little to no insulation.

Nuff Said!!

They twist out.

The fresh water tank is most likely above the rear axle. The drain you mention is in the tank to pump feed line. The drain is where you are frozen. It freezes in the drain and up into the feed line. I pushed my drain up into the skin, held it there with tape and sprayed expanding foam in...

Or you can use a pair of jumper cable as well.

Do not attempt charging them!! They can and will explode. Replace them. It is not worth having an injury or fire. They will never be safe. If you do get them to charge, the plates have been altered from the expanding ice. They will not perform as they should and will fail shortly.

Look for the hydraulic pump up front in the basement. Check for a manifold with valves on it, if you have the valves, you can select witch slide moves and which you do not.

At the pump, find the small red wire that goes to the switch, install a toggle switch in this wire. Flip it off and the landing gear switch is dead.

I installed a Reverse Osmosis drinking system in ours. There is a hidden space under the kitchen sink in our Landmark that I hid it in. Then ran a water line to the faucet on the sink and to the ice maker in the fridge. It will make a gallon of water in no time. A lot less weight than...

The switch is toast, pull it out and go to an autoparts store for a replacement. Before disconnecting the wires, take a picture.

I would not waste the time to clean them. For the cost of the labor, you can buy new shoes, matter of fact, I replaced the entire brake assembly for $30 a wheel.

Amp draw too high for the switch. Also, the crimp and/or the spade connection is loose. Loose connections cause resistance, resistance cause the amp draw to go up, the increased resistance/draw builds heat. Replace the switch with one that has at least a 20 amp capacity, and replace the ends...

If it is the vent for the fresh water tank, most likely is, the fitting needs to be pointing down. That way it won't catch dirt and anything else that could find its way in your freshwater.

Is it a dual tuner receiver?? If so, move the cable from output 1 to output 2. The 2nd tuner is controlled by a RF signal remote, while the 1st tuner is a IR signal. If it is a single tuner, you can purchase a signal repeater to control it. You point the remote at the transmitter and it...

What is the oil level??

This link indicates an April production date. http://www.donlen.com/production-trucks-chrysler.aspx

Did you flip the breakers off then back on?? If you tripped one, it may or may not go to the center. You have to cycle the breaker off then back on to reset it.

Under the slide on the outside, there is a single lip seal that is screwed in with a metal strip. I have taken it loose and repositioned it to seal properly. Then inside, I use foam pipe insulation stuffed under the edge of the slide, this stops the drafts. Also, we found that if you leave...

We wintered in our Landmark last winter while building the new house. We experienced a low of 17* with highs in the mid 20*. Never turned on the gas furnace. Used 2 of the oil filled radiator type heaters, a ceramic heater on a heavy duty thermostat in the basement, and the heat strips in the...

I had light oxidation on the front cap, they polished it out nicely. They also washed the roof. When they detailed the truck, they scrubbed the fender wells, de-haired the cab completely ( we travel with 2 dogs and a cat ), cleaned every where!!! The truck looked like it came off the showroom...

When I was in Vegas, they came to us and washed and waxed the Landmark and truck and detailed the truck inside for $300.00

Depending on how low your batteries are in the trailer, you may not get a good charge out of the truck. The truck is usually limited to only 30 amps, and the wire is a long run and only 10 gauge if you're lucky, or smaller. Plugging the trailer into shore power is the best way to charge your...

While not solar, I bought a LED low voltage landscape spot light, made a mount out of PVC fittings that slide over the flag pole and sit on the pole holder, made up a little box that I plug the trailer light cord into and the pole lite, and have a reliable light on Old Glory.

It is real simple, really! Since you want to rewire it from the front, find the blue wire in you trailer plug, this is the hot wire for the brakes. Look for the white wire, this is the ground for the whole coach. Run 2 wires to the front wheel on both sides, I used 10 gauge, one blue and one...

You don't mention the bed length of your truck. A short bed will tend to give you a rougher ride if the fifth wheel is mounted over or behind the axle. I have the Trail-Air on our Landmark, with the hitch 2" ahead of the axle, I have a very good ride and would not hesitate to go with the...

Do not tow the trailer until the bad tire is replaced. It is already coming apart, you do not need the thing to disintegrate on the road and trashing your rig.

I have owned an 08 Quad cab long bed with the 3.73 axles and 2010 Crew cab long bed with 4.10 axles. I prefer the 4.10's, while there is no real measurable difference in mileage, it does tow better, especially in the mountains, maintains speed better without shifting as much. My 2014 will have...

X2! This is where I would start, make sure the rig is level side to side.

Camped next to a guy that had that very one on his 2012 Ram 3500 DRW with a brand new Carriage fifth wheel. He had been using it for some time. He stated it was good for keeping the bugs off about half of the front cap. He said it did not make a measurable difference in mileage, but it did...

Butyl putty tape is applied under the lip of the vent and then screwed to the coach, after tightening, the excess is removed and a good caulk applied.

Could it be the fireplace???? Is it the first time you have used it?????

I don't believe that tool will work on the stainless rings shown in the picture of the OP. It is only good for the copper rings.

Re: Harrison,Arkansas campgrounds There is only one that I know of, it is on the west side of Harrison on 62. I don't remember the name, but my dad stayed there when he broke down just west of there. We live an hour away from it, it does seem to be a nice park.