Search results

To update my problem with my hydraulic system failure. I had stated that I had ordered a new solenoid as my first attempt to solve my problem. the new solenoid fixed my problem, thanks for everyone's input.

Thanks for the input, to answer some of your questions, i have been hooked up to shore power every incident except one. batteries show 13.1-13.2 when not hooked up to shore power, have checked all connections, had a load test performed on the batteries( good) . i have replaced the solenoid unit...

I have a 2013 bighorn with a six point hydraulic leveling system and hydraulic slides. Last two or three times I have moved the trailer, when I retract the living room and kitchen slides they retract super slow, the trailer lights go dim and a warning message on the fridge flash " low dc power"...

Thanks for the input everyone. I did get the fitting tightened ( hopefully for good). Yes Dan it is the anti syphon valve ( thanks) The valve does have one red, one blue pex line fitted to it , the shower has its own red and blue lines, the black tank flush works fine, the ASV connection just...

I have a 2013 Bighorn 3010RE .Behind my shower is a fitting that has a hot water and cold water pex pipe attached to it. The two pipes come up from the base of the shower and end a the black fitting. The pipes are attached by hand tightened fittings.( which was leaking) Next to impossible to get...

I have a 2013 Bighorn 3010RE. I have been wintering in Texas and Florida since buying this trailer . The Anderson Valve has been getting harder and harder to turn and now wont turn at all( with my fingers). Any suggesions?

Thanks Dave, have checked the rollers , seem to be working fine. Not sure how I will access the pulleys. Noise is coming from the motor. - - - Updated - - - I always have items under the bed as well. In my quest to discover the problem I have cycled the slide numerous times empty, with the...

I have a 2013 bighorn 3010RE with electric cable bedroom slide. I'll try to make this as short as possible. A year ago in Nov I was preparing for a trip from Nova Scotia to Texas. Just before I left, the bedroom slide motor started to make a very loud noise when extending the slide. The closer...

I have a 2013 Bighorn 3010 RE. I am from Canada, and winter in south Texas. The last two dumps ( once a week) have me wondering what is going on with my Grey water tanks. We put a lot of water down our galley tank( washing lots of dishes) and not so much down the bathroom grey water tank. I...

Re: Tetford toilet issues Foot pedal on our Style II toilet just fell off this AM in our 2013 Big Horn. Plastic crap wore out . Lucky to find replacement at local RV parts store($50.00 Am..$73.00 Ca.) Hopefully it will last longer that the original !!!!!( two years and a little)

Thanks TX....If I was only so lucky. Mine is a different unit. It is a 36" unit and does not have any access doors. It is completely surrounded by imitation brick/stone. Not looking forward to tearing apart the entertainment center to change bulb.

I have a 2013 Bighorn 3010 RE . The Greystone fireplace which is located in front of the retractable TV has a "fire" light on the left side of the unit that is burnt out( I'm guessing) . Can anyone give me a hint as how to remove the FP to replace the bulb?

I have searched these threads for help on my lack of knowledge of audio systems. So far I have drawn a blank. I know my question probably has been addressed somewhere in the long list of Q&A's on this subject but if anyone can help me I would really appreciate it. I have a 2013 BH 3010RE ...

Thanks for your help Tom?Sondra

It is a replacement, starting to figure out the process, one question, do you config the fuses when asked? Thanks Flyerone

Not quite understanding your writing down which button controlled which feature, and how did you"edit" the buttons on the remote ?

OK now I'm lost....Did everything the way I was supposed to( I think) . The awning works , the steps light works, BUT...the main slide button operates the bedroom slide, the bedroom slide button just produces a lot of clicking in the receiver, and the same with the landing gear. Can anyone help...

"BINGO" success. Thank you very much, now to get it to talk.

I have a 2013 Bighorn 3010RE. I have just received a new remote for the awning/step light/landing gear. I have to sync the remote with the receiver and have no clue where to find this device. I read on this forum once that it might be located behind the grate above the pantry. ( not there in...

Don't know where to post this but I was interested to see if any one out there has had the screen shatter on the Linc remote from pressing on it? I was outside my Bighorn extending the bedroom slide with the remote. The slide stopped before it was fully extended, so I pressed harder on the...

Thanks Jim...I just called customer service at Fantastic Vents and they are sending me a replacement wall control unit no questions asked. The gentleman indicated that they no longer purchase units from Honeywell because of reliability issues and when their stock is used up will be going to...

I have a 2013 Bighorn 3010RE with the Honeywell wall control. Worked great untill the other day . In the past, as soon as I slid the lever to the right( no more than 1/8 inch) the cover opener would engauge, lift up and start the fan. Now the wall unit will do nothing to start the fan . Do these...

Thanks sengli I did the same this morning. I called Heartland customer service before I tried my adjustments just to get conformation on which nuts to tighten and could get no satisfaction . All he was going to do was to send me the service manual . I can get that on line. I also found one of...

When my bedroom slide is fully out there id about 2" of total travel to the bottom right cable( when viewed from outside) and about 1 1/2" of total travel to the bottom left cable. Is this too much and if so is there a simple way to adjust it. The instructions on the manual seem to be geared to...

Can't say that I have ever ran out of water when dry camping. I have noticed that when backing up it seems to drain out more water than going forward or sitting still. This would indicate that the water is being forced to the forward section of the tank?

When dry camping I fill the fresh water tank when arriving at our non serviced provincial parks. On a normal stay we might only use about half of the water in the tank. When leaving , I open the drain hoping to have it emptied by the time I get home. After a forty five minute trip, it is still...

Tks for the info everyone. Got my problem solved by calling Lippert. It seems that the "feature disable" message was created when I had tried the "return to hitch level " function when I was leaving Texas to head north. The pad which I had been on all winter drops off in the front for drainage...

Hi Dave...When the left and right arrows are both pressed to have it go to hitch height( actually the point where the auto level starts) it does not do anything with the rear levelers, it just lifts the front to the hitch height( within a few centimeters ). When hitched up then the auto retract...

I have a 2013 Big Horn 3010 RE with the six point Level Up system. Recently I did a recalibration of the unit(zero setting of the control) as it was not levelling to our expectations. Since this procedure was performed( sucessfully) I haven't been able to use the return to drop off level...

Thanks for the tip MT....Sealing the gaps did the trick. Who would have thought!!!!!! I hope Heartland is aware of this and completes this task before putting n he caps.

My 2013 Bighorn 3010RE has suddenly developed a water leak in the area below the hot water heater. Funny thing is it leaks more in the morning than at other times of day. I have had the basement wall panel off and cannot find any sign of leaking behind or around the heater. The leak is showing...

I have a 2013 BH 3010RE that has the LED light strip along the base of the awning. Most of the lights have gone quite dim compared to when I first got the trailer in May. There are about six of the LED's that seem to be at the original brightness . Any one else noticed this problem?

Looks like I should have one on hand. Auto level is working great and the additive to the fluid had eliminated about 90% of the snapping noise. Thanks K.

Some time ago I posted about odor coming from under the island kitchen sink in my 2013 BH 3010RE. Everyone advised replacing the studor valve . Well....this hasn't done much to correct the issue and now there is a strong black tank odor that occurs ( in the trailer)occasionally when the kitchen...

Thanks guys. Haven't tried the cables when the slide is closed but that makes sense. Gary...Most of the time it is very quiet, but every now and then it does make a different sound when it is almost closed. Can't say for sure if I remember it as being a grinding noise or not but will take note...

Thanks to everyone for your response. I will now know where to go if this becomes a problem. In response to jjriker, the only reason I noticed the lights was that I had the overhead kitchen lights on and the welcome home light stayed on extra long due to the door being open.( all the lights went...

I have a 2013 Bighorn 3010RE. This glitch only happened once But I would like to get some thoughts on what might have happened. I was bringing in the two main slides (shore power unhooked) and the slides stopped retracting, the welcome home light went out and there was no response to the slide...

I have a 2013, Bighorn 3010RE. The bottom cables on the bedroom have about an inch of play( when I pull down or push up on them) when the slides are fully out. The top cables are very tight. Can anyone advise me as to whether this the proper tension or not. I checked with friends of ours who...

We have a 2013 BH, 3010RE, Love the solid surface counter top in the kitchen, but find that practically everything that is laid down ]on it leaves a mark or a scratch. Does anyone know of a cleaner or polishing agent that is recommended for daily cleaning that can also remove light scratches?

Thanks to all reply's. I suspected that this was the problem but wasn't sure about the procedure.